Service Interval Chart-Daily or 10 Hours-250 Hours-750 Hours

Item Daily or 10 Hours 250 Hours 750 Hours
Check Engine Oil Level and Coolant Level ·    
Drain Water Separator ·    
Check Transmission-Hydraulic Oil Level ·    
Lubricate 2WD Front Wheel Bearings, Axle Pivot Pin, Spindles, Cylinder Ends, and Tie Rod Ends * ·    
Lubricate MFWD Kingpins, Tie Rod Ends, and Axle Pivot * ·    
Lubricate Hitch Components ·    
Inspect Tires ·    
Change Engine Oil and Filter **   ·  
Check Manual Brakes   ·  
Service Batteries   ·  
Drain Fuel Tank Sump   ·  
Inspect Tractor for Loose Bolts   ·  
Check Neutral Start System   ·  
Check Transmission PARK Position   ·  
Clean Cab Air and Recirculation Filters ***   ·  
Lubricate 2WD Front Axle Pivot Pin, Steering Spindles/Cylinder Ends, and Tie Rod Ends   ·  
Lubricate MFWD Kingpins, Tie Rod Ends and Axle Pivot   ·  
Check MFWD Axle Housing and Wheel Hub Oil Level   ·  
Replace Transmission-Hydraulic Filter ***     ·
Replace Fuel Filters ***     ·
Check Air Intake System     ·
Check Engine Idle Speeds     ·
Test Coolant and Add Coolant Conditioner     ·
Clean Fuel Tank Vent Filter ***     ·
 
* Operating in extremely wet and muddy conditions
** INITIAL oil and filter change is 100 hours maximum of operation. SCHEDULED interval (250 hours) can be extended to 375 hours if PLUS-50 oil and a John Deere filter are used.
*** Interval can vary according to operating conditions

 

AG,RF30435,2623 -19-25AUG00-1/1