|
CODE SCU 22, 23
|
Battery voltage to SCV controller out of range
|
Check fuse F6
|
|
|
SCV may not operate as normally expected
|
Have your John Deere Dealer repair as soon as possible
|
|
CODE SCU 27, 28, 29
|
SCV I, or III not working correctly, controller calibration
|
Have your John Deere Dealer repair at earliest convenience
|
|
CODE SCU 45
|
Implement sensor supply power shorted
|
|
|
|
Hitch may not operate as normally expected
|
Have your John Deere Dealer repair as soon as possible
|
|
CODE SCU 47
|
Hitch following sensor voltage out of range
|
Have your John Deere Dealer repair as soon as possible
|
|
CODE SCU 48, 49
|
Remote position sensor circuit failure
|
Check implement position sensor connection when using SCV depth control
Have your John Deere Dealer repair at earliest convenience
|
|
CODE SCU 60
|
SCV communication link failure
|
Stop and restart engine
Have your John Deere Dealer repair at earliest convenience
|
|
CODE SCU 90
|
Low hydraulic oil level
|
Add hydraulic oil. See Lubrication Section
|
|
CODE SCU 98
|
Remote control system configuration failed
|
Check implement connections when using SCV depth control or SCV implement control
Must start tractor with implement connector disconnected to reset control system
|
|
CODE SCU 99
|
Remote control system configuration failed
|
Check implement connections when using SCV depth control or SCV implement control
|
| Symptom |
Problem |
Solution |
|
CODE SCU 100
|
Operator not in seat with SCV in detented flow and transmission in NEUTRAL (Warning)
|
If not stationary SCV use, return to seat or move SCV lever to NEUTRAL before leaving cab. See Operator Presence Sensor in Operator Station Section.
|
|
CODE SCU 101
|
Automatic control of implement using SCV I has been cancelled (Warning)
|
Reactivate automatic control with SCV I lever when using SCV depth control or SCV implement control
|
|
CODE SCU 102
|
Automatic control of implement using SCV III has been cancelled (Warning)
|
Reactivate automatic control with SCV III lever when using SCV scraper control or SCV implement control
|
|
CODE SCU 110-114
|
SCV I not working correctly
|
Have your John Deere Dealer repair at earliest convenience
|
|
CODE SCU 120-124
|
SCV II not working correctly
|
Have your John Deere Dealer repair at earliest convenience
|
|
CODE SCU 130-134
|
SCV III not working correctly
|
Have your John Deere Dealer repair at earliest convenience
|