|
Front-Mounted Implements:
Front frame reinforcement is recommended whenever the tractor has front-mounted dozer blades or spray tanks, is used in scraper applications, or is equipped with front frame ballast.
The reinforcement attaches to the underside of the front axle and to the outside of the front frame behind the front axle. See your John Deere Dealer for parts and assistance.
Towed Scrapers:
IMPORTANT:
Under scraper or severe applications, tighten wheel bolts every
2 HOURS
until all cap screws remain at 600 N·m (445 lb-ft).
Follow manufacturers instruction in attaching and using scraper.
|
| NON-APPROVED USES |
| |
| Spray Tanks - Mounted forward of grille screen |
| Spray Tanks - Unbalanced |
| Scrapers - Without proper tractor/scraper drawbar and frame/axle supports |
| Tiling Plows - Mounted to tractor frame or hitch |
| Fully Mounted Hitch Implements - Center of gravity greater than 609 mm (24 in.) beyond hitch points |
| Fully Mounted Hitch Implements - Total weight exceeds 6350 kg (14000 lb) - Category 4 |
| Fully Mounted Hitch Implements - Total weight exceeds 6123 kg (13500 lb) - Category 3 |
| 9420 and 9520 with Category 3 Hitch - Deep ripping/plowing applications using full horsepower (Use Category 4 hitch) |
| Extreme Draft Loads - Requiring two tractors hooked in tandem |
| Tow Hooks - Adding tow hooks is not an option |
|