Service Interval Chart Daily or 10 Hours-250 Hours-500 Hours-750 Hours

Item Daily or 10 Hours 250 Hours 500 Hours 750 Hours
Check Engine Oil Level and Coolant Level ·      
Check Transmission-Hydraulic Oil Level ·      
Drain Water from Fuel Filter ·      
Lubricate Rockshaft and Hitch Components ·      
Inspect Tires ·      
Change Engine Oil and Filter *   ·    
Service Batteries   ·    
Drain Fuel Tank Sump   ·    
Inspect Tractor for Loose Bolts   ·    
Check Neutral Start System   ·    
Check Manual Brakes   ·    
Check Transmission PARK Position   ·    
Check MFWD Wheel Hub Oil Level and Axle Housing Oil Level   ·    
Check Hi-Crop Rear Axle Housing Oil Level   ·    
Lubricate 2WD Front Axle Pivot Pins, Steering Cylinder Ends, Steering Spindles, and Tie Rod Ends **   ·    
Lubricate MFWD Axle Pivots, Kingpins, and Tie Rod Ends **   ·    
Lubricate 2WD Front Wheel Bearings **   ·    
Clean Cab Air and Recirculation Filters ***   ·    
Clean Cab Air and Recirculation Filters (Optional) ***     ·  
Lubricate Rear Axle Bearings **       ·
Replace Fuel Pre-Filter and Filter, and Bleed System ***       ·
Service Air Intake System and Pre-Cleaner ***       ·
Replace Transmission and Hydraulic Filters ****       ·
Check Engine Idle Speeds       ·
Test Coolant and Add Coolant Conditioner       ·
Clean Fuel Tank Vent Filter       ·
 
* INITIAL oil and filter change is 100 hours maximum operation. SCHEDULED interval (250 hours) can be extended to 375 hours if PLUS-50 oil and a John Deere filter are used.
** Lubricate daily or at 10 hours when operating in extremely wet or muddy conditions.
*** Interval can vary according to operating conditions.
**** Perform INITIAL hydraulic and transmission filter replacement at 100 hours maximum operation. Subsequent intervals can vary according to operating conditions.

 

RF30435,0000018 -19-04APR01-1/1