|
Perform the following steps to remove tractor from storage:
1.
Remove all coverings in cab.
2.
Unseal all openings sealed during storage
3.
Open hood and check for accumulation of dirt or debris.
4.
Install fan belt.
5.
Check all fluid levels.
6.
Fill the fuel tank.
7.
Check tire inflation pressures. (See Wheels, Tires and Treads section.)
8.
Install batteries and connect cables.
9.
Perform all 10 Hour, 250 Hour, 500 Hour and 750 Hour services as required. (See Service sections.)
|
10.
Check all instruments and indicators by turning key to the ON position.
IMPORTANT:
DO NOT operate the starter for more than 30 seconds. Wait at least two minutes for starter to cool before trying again.
11.
Operate engine at slow idle for several minutes.
IMPORTANT:
If air conditioning compressor is locked up, engine operation with compressor clutch engaged will damage belt or compressor.
12.
Check air conditioning.
13.
Check all other system functions.
14.
Warm up tractor before putting tractor under load.
|