|
Engine is ready for normal operation.
Tighten wheel and axle bolts after
3 HOURS
and after
10 HOURS
.
Check for leaks.
Operate engine at heavy loads without sustained maximum load.
Avoid idling engine longer than 5 minutes.
Closely observe coolant temperature during operation.
Check air intake system hoses and clamps.
Daily or Every 10 Hours
IMPORTANT:
John Deere Break-in Oil must be added if oil level is BELOW ADD MARK on dipstick. DO NOT fill above crosshatch pattern or FULL mark.
-
Check engine oil level
-
Check coolant level
-
Drain water and sediment from water separator
-
Check transmission-hydraulic oil level
|
-
Lubricate MFWD front axle; Axle pivot, king pins and tie rod
-
Lubricate rear axle bearings (if equipped with lubrication fittings)
-
Lubricate hitch components
-
Inspect tires
-
Drain trailer air brake accumulator (if equipped)
-
Lubricate front PTO shaft (if equipped)
At 100 Hours
IMPORTANT:
If tractor used under light load conditions during first 100 hours; Refill with John Deere Break-in Oil for an additional 100 hours to allow engine to break-in correctly. (See Fuel, Lubricants and Coolant section.)
-
Change engine oil and filter
-
Change transmission and hydraulic oil filters
-
Inspect tractor for loose hardware
Reset service hours to zero after service. (See SETTING CLOCK AND SERVICE ALARM INTERVAL in CommandCenter™ section.)
|