IMPORTANT: Use a scale to check static weight, especially with heavy implements. Static weight remaining on the front wheels with the implement lifted should always be at least 50% of the front axle weight with the implement resting on the ground.

Determine the following:

• MFWD or MFWD with Triple Link Suspension
• Front tires with or without liquid

Find implement code in John Deere implement operator's manual.

To find implement code for non-John Deere implements use the following procedure:

2. Measure distance from hitch point to center of gravity. Record the distance (mm). Divide distance by 25.4, then add 37 to this figure.

3. Determine the implement weight (fully loaded). Record the weight (kg). Multiply the weight by 2.2.

4. Multiply Step 2 by Step 3. Divide by 1000.

5. Resulting number is the implement code.

Use the prior information and refer to the appropriate chart to determine how many QUIK-TATCH weights are required.

CAUTION: Do not attempt to transport an implement without adequate front ballast. Loss of steering control may result. With maximum front ballast, do not attempt to transport an implement whose code exceeds:

• 454 for MFWD

• 474 for MFWD with TLS

NOTE: Draft links without Walterscheid (hook type) ends; If no quick-coupler is used, add 20 to code.

OUMX005,00016E6 -19-22MAR05-1/1