Hitch Set-up and Use (Quick Reference)
Once implement is attached, follow these steps for tillage operations:
Adjustments
-
Adjust raise height limit (if needed)
-
Check drop speed, adjust if needed
-
Adjust load/depth to desired draft response based on implement type and field conditions
Set Operating Depth
-
Lower implement to desired operating depth using Hitch Command lever
-
Press SET switch to save operating depth
Turn at End
-
At end of field, pull lever into raise detent and release. Hitch will raise to upper height limit.
-
After turnaround, push lever into lower detent and release. Hitch will lower to saved depth setting.
|
|