|
IMPORTANT:
Clamp-on duals should not be used for heavy traction work. They are allowed only for use when the following conditions are met including recommended tire sizes and manufacturers.
-
Clamp-on dual wheels are used only in low draft or PTO applications
-
Maximum vehicle weight is limited to 9100 kgs (20062 lbs)
-
Rear drive wheel is heavy duty cast center type
-
Current wheel sleeve cap screws and washers are replaced with cap screws and washers contained in kit AR219840 for cast drive wheel
-
Steel wheel-to-cast hub cap screws and washers are replaced with cap screws and washers contained in kit AR217153
|
-
Use rear wheel bolt tightening procedure (See TIGHTENING REAR WHEEL BOLTS in this section.)
-
Inner single wheel tread setting does not exceed 1900 mm (75 in.)
-
Outer dual wheel tread setting does not exceed 3400 mm (134 in.)
-
Average tread width of dual combination does not exceed 2650 mm (104 in.)
-
Outer tire must be of equal or smaller section width tire
-
Drive wheels and clamp-on dual tires should be inflated to the same pressure
|