Perform the following steps to remove tractor from storage:

• Remove all coverings in cab
• Unseal all openings sealed during storage
• Install alternator, fan, and compressor belt
• Check all fluid levels
• Fill the fuel tank
• Check tire inflation pressures
• Install batteries and connect cables
• Perform all 10 Hour, 250 Hour, and 750 Hour services as required
• Check all instruments and indicators by turning key to the ON position
• Disconnect fuel shut-off solenoid and crank the engine a few revolutions

  IMPORTANT: DO NOT operate the starter for more than 30 seconds. Wait at least two

minutes for starter to cool before trying again.
• Connect fuel shut-off solenoid and start engine
• Operate engine at slow idle for several minutes

  IMPORTANT: If air conditioning compressor is locked up, engine operation with compressor clutch engaged will damage belt or compressor.

• Check air conditioning
• Check all other system functions
• Warm up tractor before putting tractor under load

AG,RX15494,1913 -19-06SEP99-1/1