|
NOTE:
During break-in period, a higher than usual oil consumption can be expected.
Engine is ready for normal operation.
During the
first 100 HOURS
observe the following:
IMPORTANT:
Use ONLY John Deere ENGINE BREAK-IN OIL during the first 100 hours of operation.
IMPORTANT:
John Deere BREAK-IN OIL must be added if oil level is below the ADD mark on dipstick. DO NOT fill above the crosshatch pattern or the FULL mark.
|
-
Perform Daily or 10 Hour Service, checking engine oil and coolant levels more frequently
-
Tighten wheel and axle bolts after
3 HOURS
and after
10 HOURS.
See TIGHTEN FRONT WHEEL ATTACHING NUTS and TIGHTEN REAR WHEEL ATTACHING NUTS in Wheels, Tires and Treads section
-
Check for leaks
-
Operate engine at heavy loads without sustained maximum load
-
Avoid idling the engine longer than 5 minutes
-
Closely observe coolant temperature during operation
-
Check air intake system hoses and clamps
|