Attaching PTO-Driven Equipment

causym CAUTION: Avoid entanglement in rotating driveline which can cause serious injury or death:

Wear close fitting clothing.

Keep PTO shield and driveline shields in place at all times. Make sure rotating shields turn freely.

Make sure the PTO is switched off and stopped, the tractor engine is stopped and the ignition key removed before attempting to connect, clean, adjust or lubricate PTO-driven equipment.

1. Align swinging drawbar (A) parallel to PTO shaft and lock it in position.
2. Distance (B) from end of PTO shaft to center of pin hole in drawbar end should be 350 mm (13.8 in.) for the 540 rpm PTO and 400 mm (15.7 in.) for the 1000 rpm PTO.

If PTO splines do not align with the grooves on the drive shaft, shut off the engine. This will relieve hydraulic pressure and allow the PTO shaft to be turned and aligned by hand.

RXA0067416


A-Drawbar
B-Distance

OU1092A,0000016 -19-15JAN04-1/1