Oil Withdrawal With Hydraulic Motor

IMPORTANT: Never regulate the flow rate by means of an external valve. Always use load control valves (A).

Maximum oil flow depends on couplers and size of hydraulic pump installed on the tractor.

With the 45 cm ³ (2.74 cu. in.) pump used with 300 Series selective control valves, a flow rate of 114 l/min (30.3 gpm) can be achieved.

Stop the engine. Move the corresponding SCV control lever to the float position. Connect hydraulic hose from the hydraulic motor.

NOTE: When the control lever is pushed forward (or to the right for the multi-function lever), the pressure is applied to the upper coupler.

Start the engine. Move control lever to lower . To switch off the hydraulic motor, move the control lever to the float position. Shut off the engine and remove hydraulic hose.

IMPORTANT: Do not move control lever to the neutral position. This may result in back-pressure causing damage to the hydraulic motor and hoses.

A-Flow Control Valves

OU1092A,0000023 -19-15JAN04-1/1