OMAR228229: 9320T, 9420T, 9520T and 9620T Tractors, Block File: AG_RX15494_2364_19

Radar must be operational to provide true ground speed. If true ground speed is not available, "---" will be displayed.

NOTE: Illustration shows current track slip (C) is 4% and alarm setting at 6%. Each bar on the bar graph represents 2% slip.

1. Press % SLIP switch (A). Bar graph and numeric display will show current track slip.

2. Press switch again to display the track slip alarm setting. Alarm symbol (E) will be displayed.

NOTE: Bar graph (C) flashes when track slip exceeds alarm setting.

3. Press SET/SAVE switch (B) to change alarm value.

4. Input alarm setting using touch pad, then press SET/SAVE switch again.

NOTE: Entering "0" as an alarm value will shut off alarm.

Calibration:

Drive tractor 8 km/h (5 mph) with no load. Tracks must not be slipping.

Press the "0" ZERO switch for 4 seconds. "CAL" will be displayed during calculation.

NOTE: "Err" will flash on display field if calibration was not performed correctly. Repeat calibration procedure.

Display will return to percent slip if calibration was successful.

A-% SLIP
B-SET/SAVE
C-Bar Graph
D-Numeric Display
E-Track Slip Alarm

AG,RX15494,2364 -19-08OCT99-1/1