Perform the following steps to remove tractor from storage:

• Remove any coverings
• Unseal all openings sealed during storage.
• Install fan and alternator belts
• Inspect tracks
• Fill the fuel tank
• Install batteries and connect cables
• Perform all 10, 250, and 750 Hour -(See Lubrication and Maintenance Sections)
• Check all instruments and indicators by turning key to the ON position
• Disconnect fuel shut-off solenoid and crank the engine a few revolutions

  IMPORTANT: DO NOT operate the starter for more than 30 seconds. Wait at least two

minutes for starter to cool before trying again.
• Connect fuel shut-off solenoid and start engine
• Operate engine at slow idle for several minutes

  IMPORTANT: If air conditioning compressor is locked up, engine operation with compressor clutch engaged will damage belt or compressor.

• Check air conditioning
• Check all other system functions
• Warm up tractor before putting tractor under load

AG,RX15494,2570 -19-11OCT99-1/1