AutoTrac Steering System

NOTE: To make AutoTrac function, electrohydraulic steering is required.

1. AutoTrac assisted steering system utilizes StarFire position receiver (A), GreenStar display and mobile processor (B) to assist operator in steering tractor.

2. Operator must enter implement width minus overlap desired in GreenStar display and drive first pass in straight line keeping mark (C) in middle of tractor hood (D) on display. Operator may also enter start point and end point of desired path.

3. Pushing resume switch on CommandArm activates AutoTrac.

4. AutoTrac is a straight-line guidance system. Operator is responsible for turning vehicle at the end of each pass and for steering around obstacles such as trees, waterways, etc. in the middle of field. Operator regains control of steering by turning steering wheel.

5. Refer to AutoTrac Operator's Manual for operating instructions.

A-StarFire Receiver
B-Mobile Processor
C-Mark
D-Tractor Hood

OU1092A,0000003 -19-16AUG05-1/1