Performance Monitor-If Equipped

NOTE: Ignition switch must be in the ON position to operate performance monitor.

Performance monitor displays information related to various speeds, area, distance, time and alarm data.

Bar graph displays track slip and monitor backlight intensity.

Area, track slip, slip alarm, width, implement indicator, distance, backlight brightness, and service hours can be adjusted or preset.

A radar sensor is required for an accurate calculation of track slip, area covered, distance or speed. Without a radar sensor, values are estimates based on track speed.

NOTE: Tractors built prior to January 2003, press and hold AREA touch pad for 8 seconds to change display from English to Metric units.

Tractors built after January 2003, turn to CCU24 address Default Display Mode Type: Calibration Display Options: 000 English (mi/h, feet, etc.) 001 Metric (SI) (km/h, meters, etc.)

This address selects the default display units (English or Metric).

The default display units can be changed using the performance monitor or CCU24 address.

OURX984,000004E -19-15MAY04-1/1