Attaching PTO-Driven Implement

causym CAUTION: Entanglement in rotating driveline can cause serious injury or death.

Keep PTO shield and driveline shields in place at all times. Make sure rotating shields turn freely.

Wear close fitting clothing. Stop the engine and be sure PTO driveline is stopped before making adjustments, connections, or cleaning PTO-driven equipment.

1. Lock drawbar in center position and remove clevis assembly, if implement will be attached to drawbar. Drawbar hitch pin must be behind end of PTO shaft.

Dimension - Specification

PTO Shaft End to Hitch Pin Hole -(A) 508 mm (20 in.)

2. Attach implement to drawbar before connecting PTO driveline. If implement will be connected to quick-coupler, be sure drawbar will not interfere.

3. Connect drive line to PTO shaft. Turn shaft slightly by hand to line up splines. Be sure yoke is in correct position and firmly locked.

4. Put PTO shield in intermediate position.


A-PTO Shaft-to-Pin Hole Distance

TS198
RW26560

OURX984,0000092 -19-17OCT02-1/1