Using Draft Control

When load/depth control is turned to numbered area (A), depth is automatically varied as ground conditions require. The setting of the control depends on implement being used and field or soil conditions.

Turning the control counterclockwise reduces draft response. Turning the control clockwise increases draft response. With the control turned to a higher number (B), the implement is raised as resistance (soil density) increases and lowered as resistance decreases. Typical settings:

Integral Field Cultivator 4-5
Integral Moldboard Plow 3-5
Semi-Integral Moldboard Plow 2-4
Integral Chisel Plow 2-4
Integral Ripper/Subsoiler 1-3

 


A-Numbered Area
B-Higher Number

RW26564
RW26565

OURX984,000009B -19-17OCT02-1/1