Changing Engine Oil and Filter

SERVICE INTERVAL - 250 Hours *
 
* 375 hours if PLUS-50 oil and a John Deere Filter are used

 

IMPORTANT: Change engine oil every 125 hours if diesel fuel has a sulfur content greater than 0.5 percent.

NOTE: Oil flow may be controlled by attaching a hose to drain fitting.

1. Operate engine to warm oil. Stop engine. Turn crankcase drain fitting (A). Tighten fitting after oil drains out.

2. Remove filter (B). Remove old packing and clean filter mounting surface. Apply a thin film of oil to new packing and install new filter. Hand-tighten filter. Do not overtighten.

3. Refill crankcase with seasonal viscosity grade oil. (See Fuels, Lubricants, and Coolant Section.)

4. Start engine and check for leaks.

5. Stop engine. Recheck oil level.

Capacities with Filter
 
9320T ... 42 L (11 gal)
9420T ... 42 L (11 gal)
9520T ... 42 L (11 gal)
9620T ... 42 L (11 gal)

 
RW56162A
RW26163


A-Drain Fitting
B-Filter

OURX984,00000BE -19-11AUG06-1/1