|
3.
Remove transmission drain plug (A) to drain oil.
4.
Install transmission drain plug.
5.
Remove and clean sump screen (B).
6.
Fill Transmission/Axle with HY-GARD Hydraulic Oil at tube (C). Level should be between marks (D) and (E) on sight gauge. Fill to full mark (E) if operating on hillsides.
7.
Drive tractor at 1500 rpm. Stop engine and allow oil level to stabilize in the sight gauge for at least 5 minutes. Recheck level and fill as necessary.
| Axle/Transmission Capacities (With Filter) |
| |
| With PTO... 246 L (65 gal) |
| Without PTO... 242 L (64 gal) |
| |
A-Transmission Drain Plug
B-Sump Screen
C-Fill Tube
D-Sight Glass-Low Level Mark
E-Sight Glass-Full Level Mark
|
