Changing Transmission/Axle Oil Filter-18-Speed Powershift Transmission

NOTE: Transmission needs to be calibrated after oil filter has been replaced. See your John Deere Dealer.

SERVICE INTERVAL -
 
INITIAL - 100 HOURS
SCHEDULED - 750 HOURS

 

1. Remove transmission/axle oil filter (A) from back side of transmission.

2. Apply oil to filter packing and install new filter. Tighten one-half turn after packing contacts filter housing base.

3. Start tractor and run for 1 minute.

4. Check transmission/axle oil level at the rear of the axle housing and fill as required.

5. Add HY-GARD Transmission/Axle JDM J20C oil ONLY.

RXA0053542


A-Oil Filter

OURX984,00000C2 -19-17OCT02-1/1