Changing Hydraulic Oil

SERVICE INTERVAL - 1500 HOURS

 

Hydraulic System Capacities
 
Without Hitch... 102 L (27.0 gal)
With Hitch... 104 L (27.5 gal)
 

 

1. Remove plug (A) and drain the hydraulic reservoir.

2. Fill hydraulic reservoir with HY-GARD Hydraulic Oil specified in Fuels, Lubricants and Coolant Section, between marks on sight gauge. Tractor should be on level ground.

3. Run engine at 1500 rpm for approximately one minute to pump oil through the system.

4. Add oil to the reservoir keeping the level within the bottom of the sight gauge (B). Raise the hitch (if equipped) and continue adding oil to the reservoir until the level stops changing at the bottom of the sight gauge.

5. Operate the engine at low idle for 3 to 5 minutes with the transmission in PARK or NEUTRAL position.

6. Add oil as required until sight gauge level remains between sight gauge marks.

RXA0052028
RXA0061919


A-Plug
B-Sight Gauge

OURX984,00000C4 -19-17OCT02-1/1