Replacing Front Grille Lights

CAUTION: Wear gloves and safety glasses when handling the headlight bulbs. Bulb should cool down for three minutes after switching lights off.

The lights must never be operated without a bulb. Dangerous voltage spark-over may occur and cause damage/injury at the connector. See warnings packaged with (replacement bulb).

NOTE: Headlights will need to be adjusted when bulbs are replaced. See ADJUSTING HEADLIGHTS, in this Section.

Remove cover (A) and remove headlight adjustment screws (B).

Disconnect light wiring harness.

Halogen Light

Remove rubber seal (C) and bulb retainer (D).

Twist bulb (E) counterclockwise and pull to remove.

Replace bulb and install light in reverse order.

High Intensity Discharge (HID) Light

Place headlight on hard surface, while pushing down on light remove bulb retaining strap (F) using a flat screwdriver.

Remove bulb/starter assembly (G).

Install replacement bulb/starter assembly and retaining strap. Install headlight in reverse order.

A-Headlight Cover
B-Adjustment Screws
C-Rubber Seal
D-Bulb Retainer
E-Halogen Bulb
F-Retaining Strap
G-HID Bulb/Starter Assembly

OURX984,00000DA -19-17OCT02-1/1