Servicing the Batteries

NOTE: Factory installed batteries are maintenance free and require no additional service.

However in certain conditions such as long periods of operation at high ambient temperatures or excessive engine cranking, may require adding water. See label on battery.

CAUTION: Never use compressed air to clean batteries. It can cause a build up of static charge leading to potential injury.

Battery gas can explode. Keep sparks and flames away from batteries. Use a flashlight to check battery electrolyte level.

Never check battery charge by placing a metal object across the posts. Use a voltmeter or hydrometer.

Always remove Battery ground cable (A) first and connect it last. Do not let disconnected ground terminal touch metal surface.

Lift cover (B) to access batteries. Remove two cap screws (C) from end panel to slide batteries from battery box.

WARNING: Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling.

A-Chassis Ground (-) Cable
B-Battery Cover
C-Lift cover
D-Cap Screws

RW24911,00001E8 -19-07SEP01-1/2

CAUTION: Avoid contact with poisonous sulfuric acid in battery electrolyte. It is strong enough to burn skin, eat holes in clothing, and cause blindness if splashed into eyes.

Open covers and disconnect battery terminals.

Clean terminals and battery posts using a baking soda and water solution.

Remove any corrosion with a terminal brush.

Rinse with clean water and air dry.

Connect battery terminals and apply thin coat of grease to cable ends.

Close covers.

Keep all battery terminals (A) clean and tight.

NOTE: For replacement batteries follow manufacturer's recommendations.

A-Connections
B-Cells

RW24911,00001E8 -19-07SEP01-2/2