Dual Beam Radar
NOTE:
On tractors with factory or dealer installed dual beam radar, it is not necessary to calibrate vehicle speed.
May need to reset % slip value if:
-
Track speed and radar speed are not equal when slip is not present
-
Track slip is displayed when slip should not be present
Reset % slip value by:
-
Drive tractor on a hard level surface at a constant speed of 8.0 km/h (5 mph)
-
It is recommended to have an implement connected to the tractor but not engaged in the ground (no load).
-
Press and hold % slip touch pad (A) for a minimum of 3 seconds to zero out slip.
A-% Slip Touch Pad
|
