Operating the Radio with Optional Cassette Tape Player

RXA0065271


A-Band
B-Tape
C-Tape Reverse
D-Eject Tape


E-Auto Preset
F-Dim
G-Scan


H-Preset Stations
I-Tune
J-Seek


K-Display/Time Set
L-On/Audio/Volume
M-Power

Press the BAND button (A) to select FM1, FM2, AM, SAT (Satellite), or WX (Weather).

Press TUNE (I) once to turn to the next higher station. Press SEEK (J) once to turn to the next lower station.

Press and hold both TUNE (I) and BAND (A) to switch between manual tune mode and "seek" mode.

Holding SEEK longer than half a second begins the "seek" function. When a station with a strong enough signal is found, "seek" function will stop at that station.

Press SCAN (G) to scan all stations. When a strong enough signal is found, the station will play for 5 seconds then continue to scan until SCAN is pressed again.

Storing Preset Stations:

1. Select the desired band (FM1, FM2, AM, SAT, or WX)
2. Tune to desired station.
3. Press and hold one of the six preset buttons (H) to store the selected station.
4. Repeat procedure for remaining preset buttons.

Press AUTO (E) until "AUTO" and the "AS" icon appear to automatically store the six strongest stations of a selected band. Press AUTO again to restore original presets.

Press DISPL/TM SET button (K) to switch between displays. When the receiver is in AM, FM1, FM2, SAT, or WX, the display will switch between frequency and time of day. When the receiver is in the cassette mode, the display will switch between TP SIDE1/TP SIDE2 and the time of day.

Adjust volume, bass, treble, fade, and balance by pressing and releasing ON/AUDIO knob (L) repeatedly until desired function appears on display. Rotate ON/AUDIO knob for adjustment.

Theftlock Indicator

Theftlock LED is used to deter potential theft of radio from tractor. Radio can be configured to have LED not flash when radio is OFF.

1. With ignition on and radio turned OFF, press and hold DSPL/TM set button until HOURS digit flashes.

RW29387,000010C -19-23SEP04-1/2

2. Press and release Preset "1" button until display says FLASH OFF.
3. After about 5 seconds, display will return to time of day.
4. Check for desired operation of Theftlock LED.

NOTE: If Theftlock feature is activated, LED will flash when radio is OFF. Not all Delco radios have

the Theftlock feature. The flashing light has minimal electrical current draw and will not drain battery.


RW29387,000010C -19-23SEP04-2/2