Operating the Radio

RXA0065270


A-Band
B-Auto For tractors (Serial No. -901405) button is Scan
C-Dim For tractors (Serial No. -901405) button is Auto Preset


D-Scan For tractors (Serial No. -901405) button is Dim
E-Preset Stations


F-Tune
G-Seek
H-Display/Time Set


I-On/Audio/Volume
J-Power

Press BAND (A) to select FM1, FM2, AM, SAT or WX (Weather).

Press TUNE (F) once to tune to the next higher station. Press SEEK (G) once to tune to the next lower station.

Press and hold both TUNE (F) and BAND (A) to switch between manual tune mode and "seek" mode.

Holding SEEK longer than half a second begins the "seek" function. When a station with a strong enough signal is found, "seek" function will stop at that station.

Press SCAN (D), For tractors (Serial No. -901405) SCAN is (B), to scan all stations. When a strong enough signal is found, the station will play for 5 seconds then continue to scan until SCAN is pressed again.

Storing Preset Stations:

1. Select FM1, FM2, AM, SAT or WX.
2. Tune to desired station.

3. Press and hold one of the six preset buttons (E) to store the selected station.
4. Repeat procedure for remaining preset buttons.

Press AUTO (B), For tractors (Serial No. -901405) AUTO is (C), until "AUTO" and the "AS" icon appear to automatically store the six strongest stations of a selected band. Press AUTO again to restore original presets.

Press DISPL/TM SET (H) to switch between displays. When the receiver is in AM, FM1, FM2, SAT or WX, the display will switch between frequency and time of day.

Adjust volume, bass, treble, fade, and balance by pressing and releasing ON/AUDIO knob (I) repeatedly until desired function appears on display. Rotate ON/AUDIO knob for adjustment.

Adjust brightness of display by pressing (C) until DIM, For tractors (Serial No. -901405) DIM is (D), appears on display. Rotate ON/AUDIO knob to adjust.

RW29387,000042A -19-04OCT04-1/2

Theftlock Indicator

Theftlock LED is used to deter potential theft of radio from tractor. Radio can be configured to have LED not flash when radio is OFF.

1. With ignition on and radio turned OFF, press and hold DSPL/TM set button until HOURS digit flashes.
2. Press and release Preset "1" button until display says FLASH OFF.

3. After about 5 seconds, display will return to time of day.
4. Check for desired operation of Theftlock LED.

NOTE: If Theftlock feature is activated, LED will flash when radio is OFF. Not all Delco radios have the Theftlock feature. The flashing light has minimal electrical current draw and will not drain battery.


RW29387,000042A -19-04OCT04-2/2