Load Center Relays and Diodes (Serial No. -902202)

K1-High Beams Relay
K2-Not Used
K3-Clutch Override Relay (PCU)
K4-Front Flood Lights Relay
K5-Rear Flood Lights to Accessory Outlet Only
K6-Rear Fender Flood Lights Relay
K7-Front Grill Spot Light Grounding Relay
K8-Right Turn Lamps Relay
K9-Left Turn Lamps Relay
K10-Not Used
K11-Low Beams Relay
K12-Accessory Outlet Relay
K13-Engine Control Unit Relay
K14-Front Grill Spot Light
K15-ELX (Electronics) Relay
K16-Roof Flood Lights Relay (If Equipped)
K17-Transmission Latch Relay (PCU)
K18-Transmission Enable Relay (PCU)
K19-Fender Turn Lamps Relay
K20-Reverse Relay PST
K21-Forward Relay PST
K22-Not Neutral PST
K23-Horn Relay
K24-Wiper Circuit Relay
K25-Intermittent Wiper Pulse Relay
K26-Intermittent Wiper Enable Relay
K27-Accessory Relay
K28-Blower Motor Circuit Relay
K29-Calibration Mode Relay (PCU)
K30-Pressurizer Blower Motor Relay
K31-Not Used
K32-Not Used
K33-Not Used
K34-Not Used
K200-Purge Relay
K220-ATC Diagnostic Relay
K300-Shipping Relay
K301-Starter Relay
K500-Back-Up Alarm Relay
V1-Diode Block 1 (DB1) Power Supply, Starting and Charging Circuits, Lighting Circuits and PowerShift Transmission Circuits
V2-Diode Block (DB2)

RW29387,000069A -19-19APR04-1/2

NOTE: Relays Not on Load Center-Shipping Relay, Starter Relay, and Back-up Alarm

K200/K220 are accessed by removing rear cab cover and black inner panel that control units mount to.

K500 is located along side LH rear ROPS post. Remove back window latch and LH pencil tray form inside rear of cab. Pull side cover ahead slightly, fuse and relay are along side post.

RW29387,000069A -19-19APR04-2/2