Installing and Using Clevis Assembly

IMPORTANT: Remove clevis assembly before using PTO shaft, or whenever PTO shaft might cause interference.

Clevis assembly (A) must be attached ONLY to top of drawbar.

Install clevis assembly and tighten cap screws (B).

Clevis Assembly Retaining Cap Screws - Specification

Category 3 Cap Screws -Torque 610 N·m (450 lb-ft)
Category 4 Cap Screws -Torque 430 N·m (320 lb-ft)

RXA0053184


A-Clevis Assembly
B-Cap Screws

OURX935,000005B -19-19MAY05-1/2

Clevis assembly (A) must be attached ONLY to top of drawbar.

Remove lock pin (B). Lift pin with handle (C) and position in notch of clevis assembly.

Attach implement.

IMPORTANT: Insert pin only through drawbar, not through clevis assembly, if towed implement also has a clevis assembly. DO NOT insert pin through all four members.


A-Clevis Assembly
B-Lock Pin
C-Handle

RXA0053185
RXA0053186
RXA0053187

OURX935,000005B -19-19MAY05-2/2