Attaining Optimum Performance
BEFORE adding ballast to your tractor, consider these important factors to attain optimum performance:
-
Total tractor weight and static weight split (percent of static weight on front and rear)
-
Type of operation
-
Type of tractor and implement set-up
Recommended Weight Split
Tractor should be weighed to accurately determine amount and type of ballast. Weight should be distributed depending on how tractor is equipped and the conditions in which it will be operated.
NOTE:
Ideal weight split is 55 percent front, 45 percent rear, of total tractor weight.
Correct Ballast
Use no more ballast than necessary, and adjust ballast as tractor use changes.
For correct ballast, measure amount of travel reduction (% slip) of the track. Under normal field conditions, travel reduction should be 2-5 percent. Add more weight to tractor if slip is excessive. If there is less than minimum percent slip, ballast should be removed, unless needed for stability.
Correct ballast allows most efficient use of tractor's available power but will not make up for an implement which is too big for the tractor. Adding ballast will not improve performance, if engine speed falls below rated speed and/or track slip is not beyond the recommended range.
Correct Track Size
Wide tracks with wide tread settings provide the best tractor stability, steering performance and overall
|
tractive efficiency. Sixteen inch tracks are necessary for narrow row spacing, but when performing seed bed preparation and fall tillage, setting the tracks out to a wider tread spacing will greatly improve steering and tractive performance.
Selecting Ballast Carefully
Factors Determining Amount of Ballast
-
Soil surface-loose or firm
-
Type of implement-integral/semi-integral or towed
-
Travel speed-slow or fast
-
Tractor power output-partial or full load
-
Track-size and tread spacing
Pulling a lighter load at a higher speed is more economical and more efficient than pulling heavier loads at a lower speed.
| Too Little Ballast |
Too Much Ballast |
| Excessive slip |
Soil compaction |
| Power loss |
Power loss |
| Track wear |
Increased load |
| Fuel waste |
Fuel waste |
| Lower productivity |
Lower productivity |
Ballast Limitations
IMPORTANT:
Tractor weight exceeding heavy ballast limits should be avoided and may void the warranty due to "overload" conditions.
Ballast should be limited to a maximum of 14301 kg (31500 lb) for satisfactory powertrain life; this weight limit includes any added ballast.
|