|
Insufficient transport clearance
|
Center link too short
|
Adjust center link
|
|
|
Center link in wrong position
|
Put tractor center link in correct hole. See section 50, Hitch.
|
|
|
Lift links too short
|
Adjust lift links
|
|
|
Implement not level
|
Level implement
|
|
|
Implement not correctly adjusted
|
See implement operator's manual
|
|
|
Upper height limit not correctly set
|
Adjust upper height limit in CommandCenter
|
|
|
Independent Link Suspension leveling not functioning correctly or extended above level
|
Induce leveling with engine operating by depressing clutch and putting transmission in gear for four seconds. Repeat until suspension is in normal operating position.
|
|
Hitch fails to follow lever
|
Malfunction in lever position sensor circuit or hitch position sensor
|
See your John Deere dealer
|
|
Poor position control
|
Load/depth mix control on wrong position
|
Adjust load/depth mix control to the left
|
|
|
System is reset
|
Enable system
|
|
|
Malfunction in lever position sensor circuit or hitch position sensor
|
See your John Deere dealer
|
|
|
Independent Link Suspension leveling not functioning correctly during large draft changes
|
Induce leveling with engine operating by depressing clutch and putting transmission in gear for four seconds. Repeat until suspension is in normal operating position.
|
|
Hitch drops slowly
|
Hitch rate-of-drop control not correctly set
|
Adjust rate-of-drop through settings in CommandCenter
|
| Symptom |
Problem |
Solution |
|
Hitch fails to lift or lifts slowly
|
Excessive load on hitch
|
Reduce load
|
|
|
Center link in wrong position
|
Put center link in upper hole
|
|
|
Hitch valve leak
|
See your John Deere dealer
|
|
|
Raise limit switch setting maybe limiting lift
|
Check settings in CommandCenter
|
|
Implement will not operate at desired depth
|
Lift links too short
|
Adjust lift links
|
|
|
Lack of penetration
|
See implement operator's manual
|
|
|
Draft sensor failed
|
See your John Deere dealer
|
|
Insufficient or no hitch response to draft load
|
Load/depth mix control in wrong setting
|
Adjust load/depth mix control in the CommandCenter hitch settings
|
|
|
Rate-of-drop too slow
|
Adjust rate-of-drop in the CommandCenter hitch settings
|
|
Hitch too responsive
|
Load/depth mix control not correctly set
|
Adjust load/depth mix control in the CommandCenter hitch settings
|
|
Hitch settles too fast after tractor is parked and engine is shut off
|
Internal circuit leakage
|
See your John Deere dealer
|
|
Hitch will not move (controls not working, including rear raise/lower switch)
|
Fuse blown
|
Replace F30 fuse
|
|
External raise/lower switch will not move hitch
|
Failure of raise/lower switch, connector, or wiring harness
|
See your John Deere dealer
|
|
|
Lever in transport lock
|
Unlock hitch at CommandCenter
|