|
1.
Remove all coverings placed in or on tractor while preparing for storage.
IMPORTANT:
To avoid engine damage, make sure crankcase vent tube is unsealed after storage.
2.
Unseal all openings sealed during storage.
3.
Check auxiliary drive belt for cracking and if serviceable, install auxiliary drive belt on air conditioner pulley.
4.
Check all fluid levels.
5.
Fill fuel tank.
6.
Check tire inflation pressures. (See Wheels, Tires and Treads section.)
|
7.
Install batteries and connect cables.
8.
Turn key to
RUN
position for one minute to allow fuel system to prime, then start engine.
NOTE:
While operating engine at slow idle, visually check all instruments and indicators to ensure they function properly.
9.
Operate engine at slow idle for several minutes.
10.
Perform all daily/10 Hour services and any other scheduled services as required. (See Service sections.)
11.
Warm up tractor before putting tractor under load.
|