|
Tighten wheel and axle bolts after
3 HOURS
,
10 HOURS
and daily for the first week of operation.
Operate engine at heavy loads without sustained maximum load.
Avoid idling engine longer than 5 minutes.
Daily or Every 10 Hours
IMPORTANT:
John Deere Break-in Oil must be added if oil level is BELOW ADD MARK on dipstick. DO NOT fill above crosshatch pattern or FULL mark.
-
Check engine oil level
-
Check coolant level
-
Check transmission-hydraulic oil level
-
Lubricate front axle:
1
-
Non-driving front axle; Pivot pin, wheel bearings, steering spindles/cylinder ends and tie rod ends
1
-
MFWD; Axle pivot, king pins and tie rod
1
|
-
Lubricate hitch components
-
Inspect tires to make sure tires have no cuts or punctures.
-
Drain moisture from the trailer brake air pressure tank (if equipped).
At 100 Hours
IMPORTANT:
If tractor is used under light load conditions during first 100 hours; Refill with John Deere Break-in Oil for an additional 100 hours to allow engine to break-in correctly. (See Fuel, Lubricants and Coolant section.)
-
Change engine oil and filter
Reset service hours to zero after service. See Setting Clock and Service Alarm Interval in the CommandCenter section.
|