Check electrolyte level and specific gravity

Low charging voltage

Have your John Deere™ dealer check charging circuit

High resistance in charging circuit

Have your John Deere Dealer check charging circuit

Indicator malfunction

Have your John Deere Dealer check indicator

Increase speed

Auxiliary drive belt slipping, not charging alternator

Check auxiliary drive belt tension

Defective battery

Check electrolyte level and specific gravity

Defective alternator

Have your John Deere Dealer check alternator

Excessive electrical load

Decrease load

Check wiring connections

Defective regulator

Have your John Deere Dealer check alternator

The 8030 series tractors use solid-state electronic drivers instead of relays to control the turn signal lights. The tractor warning system provides a turn signal indicator beep replacing the relay clicking noise.

Clean and tighten connections

Sulfated or worn-out batteries

Check electrolyte level and specific gravity

Loose or defective alternator belt

Adjust auxiliary belt tension or replace belt

Place transmission in PARK

Faulty or maladjusted neutral start switch or starter solenoid malfunction

See your John Deere Dealer

Loose or corroded connections

Clean and tighten loose connections

Low battery output

See your John Deere Dealer

Blown fuse 1

Replace fuse

Check electrolyte level and specific gravity

Crankcase oil too heavy

Use correct viscosity oil

Loose or corroded connections

Clean and tighten loose connections

Replace fuse

Clean and tighten connections

Sulfated or worn out batteries

Check electrolyte level and specific gravity

Blown master fuse

Replace master fuse (in battery compartment)

Check for stored codes, total cab electrical load may be exceeding solid state load center capacity

Blown fuse 3

Replace fuse

See your John Deere Dealer

OURX935,0000657-19-20090912