Lubricating MFWD Axle

RXA0098557
RXA0098557-UN-16JUN08

Kingpins, Tie Rods and Steering Cylinder

A - Kingpin Fittings, Bottom

B - Tie Rod Fittings

C - Steering Cylinder Fittings

D - Axle Pivot Fittings

E - Kingpin Fitting, Top, Right Side

F - Kingpin Fittings, Top, Left Side

Use John Deere™ SD Polyurea grease or other grease as specified in Fuel, Lubricants and Coolant section. In extremely wet conditions or where ac is used, service daily or every 10 Hours.

Kingpins—Lubricate fittings (A, E, and F) until grease appears at orifice on bottom end of each kingpin bearing.

Tie Rods—Lubricate fittings (B).

Steering Cylinder—Lubricate fittings (C).

Axle Pivot—Lubricate front and rear fittings (D).

John Deere is a trademark of Deere & Company

OURX935,0000B27-19-20090902