Perform the following steps to remove tractor from storage:

• Remove any coverings placed in or on tractor while preparing for storage
• Unseal all openings sealed prior to storage
• Rotate A/C compressor pulley several turns
• Install auxiliary drive belts on air conditioner pulley and fan pulley
• Check all fluid levels
• Inspect tires and check tire inflation pressures. (See Wheels, Tires and Treads Section)
• Fill the fuel tank
• Install batteries and connect cables
• Perform all services for daily, 10 , 250 , 500 or 750 Hour Interval-(See Lubrication And Maintenance Sections)
• Check all instruments and indicators by turning key to the ON position

  IMPORTANT: Removing F24 fuse will allow engine to turn over without starting. Performing this step will allow engine oil to be circulated before actually starting engine.

• Remove ECU fuse F24 to prevent engine from starting
• Crank the engine a few revolutions
• Reinstall ECU fuse F24

  IMPORTANT: DO NOT operate the starter for more than 30 seconds. Wait at least two minutes for starter to cool before trying again.

• Start engine
• Operate engine at slow idle for several minutes

  IMPORTANT: If air conditioning compressor is locked up, engine operation with compressor clutch engaged will damage belt or compressor.

• Check air conditioning
• Check all other system functions
• Warm up tractor before putting engine under load

BB92646,0000113 -19-23OCT07-1/1