|
NOTE:
Electrohydraulic steering is required for AutoTrac to function.
Refer to AutoTrac Operator's Manual for detailed instructions.
Refer to Maintenance and Service Interval Section for daily lubrication for hinge and steering cylinder pins.
-
AutoTrac system utilizes StarFire position receiver (A) and GreenStar display (B), (C) or (D) to assist operator in steering tractor.
-
AutoTrac steers the vehicle on operator-defined paths through the field. Operator must turn vehicle at the end of each pass and to go around any field obstacles. Steering control is obtained by simply turning steering wheel.
A-Position Receiver
B-GSD 4 Display / Mobile Processor
C-GSD 2100 Display
D-GSD 2600 Display
|
