| Powershift Transmission Control Unit (PTP) Diagnostic Trouble Codes |
| Diagnostic Trouble Code |
Display |
Solution |
| PTP 000126.16 |
Transmission Oil Filter Restricted |
Change Filter. If code returns, have your John Deere dealer repair as soon as possible. |
| PTP 000126.31 |
Both Transmission Oil Filters Restricted |
Change Filters. If code returns, have your John Deere dealer repair as soon as possible. |
| PTP 000127.01 |
Transmission System |
Transmission oil pressure sensor voltage problem. Have your John Deere dealer repair as soon as possible. |
PTP 000127.03
PTP 000127.04 |
Transmission oil pressure low |
Transmission Oil Pressure Very Low. Check transmission/hydraulic oil level. |
| PTP 000168.04 |
Transmission System |
PTP Supply Voltage Problem. Visually inspect around the batteries and alternator for damage or accumulated debris. Have your John Deere dealer repair as soon as possible. |
| PTP 000177.00 |
Transmission Oil Temperature High |
Transmission Oil Temperature High-Stop Engine. Have your John Deere dealer repair as soon as possible. |
PTP 000177.03
PTP 000177.04 |
Transmission System |
Transmission Oil Temperature Sensor Problem. Have your John Deere dealer repair as soon as possible. |
| PTP 000177.16 |
Transmission Oil Temperature High |
Transmission Oil Temperature High-Warning. Have your John Deere dealer repair as soon as possible. |
| PTP 000177.17 |
Transmission Oil Temperature Low |
Gear Limited to 14F Due to Cold Oil. Slow engine speed to less than 1500 rpm and heat hydraulic oil with a jumper hose as soon as possible. |
| PTP 000190.01 |
Transmission System |
Engine Speed Low. Speed up engine. |
| PTP 000190.02 |
Transmission System |
Engine Speed Conflict. Have your John Deere dealer repair as soon as possible |
| PTP 000190.18 |
Engine Speed |
Engine Speed too Low for Wheel Speed |
| PTP 000191.02 |
Transmission System |
Output Speed Conflict. Have your John Deere dealer repair as soon as possible |
| PTP 000191.14 |
Park System |
Output #1 Speed Detection Fault. Have your John Deere dealer repair as soon as possible |
| PTP 000619.31 |
Park System |
Park Solenoid #1 Circuit Fault. Have your John Deere dealer repair as soon as possible. |
| PTP 000628.12 |
Programming |
PTP Programming. |
| PTP 000630.02 |
Transmission System |
PTP Calibration Fault/Data Invalid. Have your John Deere dealer repair as soon as possible. |
| PTP 000630.13 |
Transmission Not Calibrated. |
PTP Calibration Fault/Not Calibrated. Have your John Deere dealer repair as soon as possible. |
| PTP 000630.14 |
Transmission Calibration |
|
| PTP 000639.09 |
Communication System |
Engine Speed and/or Torque Message Missing. Have your John Deere dealer repair as soon as possible. |
PTP 000734.05
PTP 000734.06 |
Electrical Clutch |
Clutch C1 Solenoid Circuit Fault. Have your John Deere dealer repair as soon as possible. |
PTP 000735.05
PTP 000735.06 |
Electrical Clutch |
Clutch C2 Solenoid Circuit Fault. Have your John Deere dealer repair as soon as possible. |
| Powershift Transmission Control Unit (PTP) Diagnostic Trouble Codes |
| Diagnostic Trouble Code |
Display |
Solution |
| PTP 002005.09 |
Communication System |
ACU Message Missing. Shift in and out of Neutral. If code returns, have your John Deere dealer repair as soon as possible. |
| PTP 002049.09 |
Communication System |
Cab Control Unit Message Missing. Have your John Deere dealer repair as soon as possible. |
| PTP 522431.12 |
Transmission System |
Ram Test Failure. Have your John Deere dealer repair as soon as possible. |
| PTP 523436.31 |
Transmission System |
Software Watchdog Timeout/Bad Power-Down. Have your John Deere dealer repair as soon as possible. |
| PTP 523438.12 |
Transmission System |
Configuration Memory Test Failure. Have your John Deere dealer repair as soon as possible. |
| PTP 523953.02 |
Operator Controls |
Speed Control Lever Sensor Circuit Conflict. Shift to PARK. If code returns, have your John Deere dealer repair as soon as possible. |
| PTP 523956.18 |
Transmission System |
No Motion Detected-Engine Off. Have your John Deere dealer repair as soon as possible. |
| PTP 523959.31 |
Transmission System |
No Motion Detected-Engine Running. Have your John Deere dealer repair as soon as possible. |
| PTP 523960.31 |
Operator not in seat |
Operator Not Seated During Reverser Command. Be sure operator is firmly seated in the seat. If code returns, have your John Deere dealer repair as soon as possible. |
| PTP 523978.04 |
Transmission System |
Speed Clutch Power Missing. Have your John Deere dealer repair as soon as possible. |
| PTP 524020.31 |
Operator Controls |
Transmission In Gear at Power Up. Move shift lever to PARK and restart. |
| PTP 524044.16 |
Axle Oil Filter Restricted |
Change Filter. If code returns, have your John Deere dealer repair as soon as possible. |
| PTP 524173.02 |
Operator Controls |
Clutch Pedal Position Data out of Range. Have your John Deere dealer repair as soon as possible. |
| PTP 524173.18 |
Clutch Partially Engaged |
Operator Attempting to Shift Above 13F With Clutch Partially Engaged. |
| PTP 524228.04 |
Park System |
Park Solenoid #2 Output Fault. Have your John Deere dealer repair as soon as possible. |
PTP 524232.03
PTP 524232.04 |
Park System |
Park Brake Pressure Sensor Circuit Voltage Problem. Have your John Deere dealer repair as soon as possible. |
| PTP 524232.16 |
Park System |
Park Brake Pressure High/Park Commanded. Have your John Deere dealer repair as soon as possible. |
| PTP 524232.18 |
Park System |
Park Brake Pressure Low/Park Not Commanded. Have your John Deere dealer repair as soon as possible. |
| PTP 524248.31 |
Park System |
Vehicle Motion With Park Brake Engaged. Have your John Deere dealer repair as soon as possible. |
| PTP 524250.31 |
Park System |
Park Brake Previously Failed/May Not Hold. Have your John Deere dealer repair as soon as possible. |
PTP 524254.03
PTP 524254.04 |
Transmission System |
Transmission Enable Circuit Voltage Fault. Have your John Deere dealer repair as soon as possible. |
| PTP 524258.02 |
Transmission System |
Invalid Gear Request Received. |
| PTP 524262.09 |
Communication System |
Gear Command Message Missing. Have your John Deere dealer repair as soon as possible. |
| PTP 524263.02 |
Transmission System |
Fifth Stage Speed Conflict. Have your John Deere dealer repair as soon as possible. |
| Powershift Transmission Control Unit (PTP) Diagnostic Trouble Codes |
| Diagnostic Trouble Code |
Display |
Solution |
| PTP 524264.12 |
Transmission System |
PTP EOL Data Fault. Have your John Deere dealer repair as soon as possible. |
PTP 524266.05
PTP 524266.06 |
Electrical Clutch |
Clutch R Solenoid Circuit Fault. Have your John Deere dealer repair as soon as possible. |
| PTP 524267.16 |
Clutch Partially Engaged |
Clutch Slipping Too Long. Insure foot is not resting on clutch pedal. If code returns, have your John Deere dealer repair as soon as possible. |
| PTP 524267.31 |
Clutch Partially Engaged |
A Brake (AB) or B Clutch (BC) Slipping Too Long. Insure foot is not resting on clutch pedal. If code returns, have your John Deere dealer repair immediately. |
PTP 524268.05
PTP 524268.06 |
Electrical Clutch |
Clutch M Circuit Fault. Shift to Neutral. If code returns, have your John Deere dealer repair as soon as possible. |
PTP 524269.05
PTP 524269.06 |
Electrical Clutch |
Clutch L Circuit Fault. Shift to Neutral. If code returns, have your John Deere dealer repair as soon as possible. |
PTP 524270.05
PTP 524270.06 |
Electrical Clutch |
Clutch H Circuit Fault. Shift to Neutral. If code returns, have your John Deere dealer repair as soon as possible. |
PTP 524271.05
PTP 524271.06 |
Electrical Clutch |
Clutch C Circuit Fault. Shift to Neutral. If code returns, have your John Deere dealer repair as soon as possible. |
PTP 524272.05
PTP 524272.06 |
Electrical Clutch |
Clutch B Circuit Fault. Shift to Neutral. If code returns, have your John Deere dealer repair as soon as possible. |
PTP 524273.05
PTP 524273.06 |
Electrical Clutch |
Brake A Valve Circuit Fault. Shift to Neutral. If code returns, have your John Deere dealer repair as soon as possible. |
| PTP 524277.00 |
Engine Overspeed |
Engine Speed Too High For Downshift. Slow vehicle before downshifting. Have your John Deere dealer repair as soon as possible. |
| PTP 524279.31 |
Transmission in neutral |
Operator Not Seated With Transmission In Neutral. Be sure operator is firmly seated in the seat. Have your John Deere dealer repair as soon as possible. |
| PTP 524280.31 |
Park Delayed |
Vehicle Motion While Shifting to Park. Lever has been placed in PARK and is coming ON when vehicle speed is less than 4 km/h (2.5 mph). |
| PTP 524281.02 |
Park System |
Output #2 Speed Detection Fault. Have your John Deere dealer repair as soon as possible. |
| PTP 524282.31 |
Transmission System |
Shuttle Shift Prevented Due to High Ground Speed. Slow tractor and repeat shuttle shift. |
| PTP 524284.02 |
Transmission System |
Cylinder Speed Conflict. Have your John Deere dealer repair as soon as possible. |