|
IMPORTANT:
If the tractor will not be used for several months, the following recommendations for storage and removal from storage will minimize corrosion and deterioration.
NOTE:
Whenever possible store tractor in a building or under a roof to avoid damage resulting from prolonged exposure to the elements.
-
Lower hitch, if equipped.
-
Change engine oil and replace the filter.
-
Service the air cleaner.
-
Drain the fuel tank and add back 10 L (2.5 gal) of fuel.
-
Remove ECU fuse
F24
to prevent engine from starting.
-
Crank engine a few revolutions.
-
Reinstall ECU fuse
F24.
-
Seal air inlets, exhaust, crankcase fill cap, fuel tank cap, radiator overflow hose, and transmission and hydraulic system fill cap using plastic bags and tape.
-
Release tension on auxiliary drive belts. Remove belt from air conditioner pulley and fan pulley.
-
Remove and store batteries in a cool dry location-(keep batteries charged)
1
.
-
Coat all exposed (machined) metal surfaces such as lift cylinders and steering cylinder rods with light coat of grease.
-
Thoroughly clean tractor touching up any scratched or chipped painted surfaces
|
-
Wax entire tractor.
-
Protect tires from heat and sunlight:
-
Raise tires off the ground
2
-
Cover wheels with water-proof tarpaulin
-
Avoid storing at temperatures greater than 29° C (85° F)
-
Avoid direct sunlight
-
Lubricate all grease fittings.
-
If tractor must be stored outside, follow additional precaution:
Cover instrument panel, control levers, and seat with sheets of material or cardboard or cover entire tractor with waterproof material to protect against the sun's rays.
-
Rotate A/C compressor pulley several turns once a month to prevent seizure of compressor.
IMPORTANT:
Compressor requires lubrication to maintain sealing function to retain refrigerant. Start engine and run air conditioner once a month during seasonal storage time to let compressor circulate lubricant throughout system and recharge batteries.
IMPORTANT:
If system is not cooling properly, turn air conditioning switch off to avoid possible compressor damage.
|