Changing Engine Oil and Filter

SERVICE INTERVAL
 
INITIAL - 100 HOURS
SCHEDULED - 250 HOURS *
 
* Interval can be extended to 375 hours if PLUS-50 oil and a John Deere filter are used

 

IMPORTANT: Change engine oil every 125 hours if diesel fuel has a sulfur content greater than 0.5 percent.

Operate engine to warm oil. Stop engine. Turn crankcase drain fitting (A). Tighten fitting after oil drains out.

NOTE: Oil flow can be controlled by attaching a hose to the drain fitting.

Remove filter (B). Remove old gasket and clean filter mounting surface. Apply a thin film of oil to new gasket and install new filter. Hand-tighten filter. Do not overtighten.

Refill crankcase with seasonal viscosity grade oil. (See Fuels, Lubricants, and Coolant Section.)

Capacities with Filter
 
9430 ... 42 L (11 gal)
9530-9630... 60 L (15.75 gal)
 

 

Start engine and check for leaks.

Stop engine. Recheck oil level.

RXA0090315
RXA0090317


A-Engine Drain Fitting
B-Oil Filter

OU1092A,0000201 -19-27MAR07-1/1