Change In Ground Level
Ground level is not a common operator adjustment.
However, ground level may need to be reset if a change to the system is made such as:
1.
AutoLoad is newly installed.
2.
A different AutoLoad scraper is connected to the tractor
3.
The front and rear scrapers are switched
4.
A scraper sensor is replaced
5.
Blade configuration is changed
6.
After blade replacement
7.
Excessive blade wear
Result Of Incorrect Ground Level Settings
1.
On entry, draft load does not increase.
2.
On entry, the draft load comes up too quickly. Typically a sharp edge will be visible in the soil where the blade initially contacts the ground.
|