SV Diagnostic Trouble Codes

In column one of the following table only SV and the trouble code is listed without being followed by a Roman numeral. That is because the same trouble codes are available for each of the seven select control valves available on this tractor.

SV Diagnostic Trouble Codes (SCV 1 Through SCV VII)
Diagnostic Trouble Code Display Solution
SV 000158.03 Switched Supply Voltage High Switched supply voltage to Selective Control Valve Unit I (SV) above 16.0 V.
SV 000158.04 SV Switched Supply Voltage Low Switched supply voltage to Selective Control Valve Unit I (SV) below 9.0 V.
SV 002034.09 SCC Message Missing Code Caused By: Selective Control Valve Unit I (SV) not receiving required messages from the SCC.
SV 004084.07 SV Not in Float Position Selective Control Valve Unit I (SV) not going into FLOAT position.
SV 004084.16 SV Overshot Commanded Position Selective Control Valve Unit I (SV) valve spool is over-shooting it's desired position.
SV 004084.18 SV Failed to Reach Commanded Position Selective Control Valve Unit I (SV) valve spool is under-shooting it's desired position.
SV 004085.07 SV Not in NEUTRAL Position Selective Control Valve Unit I (SV) valve is not in NEUTRAL position.
SV 004085.12 SV Control Unit Fault Selective Control Valve Unit I (SV) software failed to execute in allotted time.

 

OURX935,0000093 -19-14AUG08-1/1