|
PTP-70.2
|
Info
|
Data Erratic, Intermittent or Incorrect
|
|
PTP-70.14
|
Info
|
Park brake is manually engaged while trying to move the vehicle
|
|
PTP-168.3
|
Service Alert
|
Battery voltage out of range high.
|
|
PTP-168.4
|
Service Alert
|
Battery voltage out of range low.
|
|
PTP-237.31
|
Info
|
VIN or VIN Security message missing or incorrect.
|
|
PTP-628.2
|
Info
|
Controller Malfunction: EE checksum invalid.
|
|
PTP-628.12
|
Info
|
Controller is in Boot Block.
|
|
PTP-629.12
|
Info
|
Controller Malfunction: Watchdog Timer Reset.
|
|
PTP-1504.14
|
Info
|
Operator out of seat during AutoTrac.
|
|
PTP-1638.9
|
Info
|
Hydraulic oil temperature message not received on CAN bus (No
communications data)
|
|
PTP-2000.9
|
Stop
|
CAN Bus message containing engine speed from control unit ECU
is not arriving on time or missing.
|
|
PTP-3509.3
|
Service Alert
|
Supply voltage to SID out of range high.
|
|
PTP-3509.4
|
Service Alert
|
Supply voltage to SID out of range low.
|
|
PTP-3510.3
|
Service Alert
|
Supply voltage to secondary handle position and right motor
speed sensors out of range high. Voltage > 5.25V.
|
|
PTP-3510.4
|
Service Alert
|
Supply voltage to secondary handle position and right motor
speed sensors out of range low. Voltage < 4.75V.
|
|
PTP-3511.3
|
Service Alert
|
Supply voltage to trim/varitorque pot position sensor out of
range high. Voltage > 5.25V.
|
|
PTP-3511.4
|
Service Alert
|
Supply voltage to trim/varitorque pot position sensor out of
range low. Voltage < 4.75V.
|
|
PTP-3512.3
|
Service Alert
|
Supply voltage to primary handle position and left motor speed
sensors out of range high. Voltage > 5.25V.
|
|
PTP-3512.4
|
Service Alert
|
Supply voltage to primary handle position and left motor speed
sensors out of range low. Voltage < 4.75V.
|
|
PTP-3648.13
|
Service Alert
|
Data conflict between neutral switch and hydro handle position,
force system to neutral.
|
|
PTP-520296.5
|
Stop
|
The right pump secondary forward drive circuit has failed. Current
feedback is out of range low.
|
|
PTP-520296.6
|
Stop
|
The right pump secondary forward drive circuit has failed. Current
feedback is out of range high.
|
|
PTP-520297.5
|
Stop
|
The right pump secondary reverse drive circuit has failed. Current
feedback is out of range low.
|
|
PTP-520297.6
|
Stop
|
The right pump secondary reverse drive circuit has failed. Current
feedback is out of range high.
|
|
PTP-520298.5
|
Stop
|
The left pump secondary forward drive circuit has failed. Current
feedback is out of range low.
|
|
PTP-520298.6
|
Stop
|
The left pump secondary forward drive circuit has failed. Current
feedback is out of range high.
|
|
PTP-520299.5
|
Stop
|
The left pump secondary reverse drive circuit has failed. Current
feedback is out of range low.
|
|
PTP-520299.6
|
Stop
|
The left pump secondary reverse drive circuit has failed. Current
feedback is out of range high.
|
|
PTP-520378.0
|
Service Alert
|
The right pump primary reverse drive circuit has failed. Current
feedback is above normal, Short to battery.
|
|
PTP-520378.1
|
Service Alert
|
The right pump primary reverse drive circuit has failed. Current
feedback is below normal, Short to ground.
|
|
PTP-520378.5
|
Service Alert
|
The right pump primary reverse drive circuit has failed. Current
feedback is out of range low.
|
|
PTP-520378.6
|
Service Alert
|
The right pump primary reverse drive circuit has failed. Current
feedback is out of range high.
|
|
PTP-520378.31
|
Info
|
The right pump primary reverse drive circuit has failed. Current
feedback is not within 5mA of commanded current.
|
|
PTP-520379.0
|
Service Alert
|
The right pump primary forward drive circuit has failed. Current
feedback is above normal, Short to battery.
|
|
PTP-520379.1
|
Service Alert
|
The right pump primary forward drive circuit has failed. Current
feedback is below normal, Short to ground.
|
|
PTP-520379.5
|
Service Alert
|
The right pump primary forward drive circuit has failed. Current
feedback is out of range low.
|
|
PTP-520379.6
|
Service Alert
|
The right pump primary forward drive circuit has failed. Current
feedback is out of range high.
|
|
PTP-520379.16
|
Service Alert
|
The right pump max forward drive current is out of range high.
Calibration value is out of spec.
|
|
PTP-520379.31
|
Info
|
The right pump primary forward drive circuit has failed. Current
feedback is not within 5mA of commanded current.
|
|
PTP-520380.0
|
Service Alert
|
The left pump primary forward drive circuit has failed. Current
feedback is above normal
|
|
PTP-520380.1
|
Service Alert
|
The left pump primary forward drive circuit has failed. Current
feedback is below normal
|
|
PTP-520380.5
|
Service Alert
|
The left pump primary forward drive circuit has failed. Current
feedback is out of range low, short to ground
|
|
PTP-520380.6
|
Service Alert
|
The left pump primary forward drive circuit has failed. Current
feedback is out of range high, short to battery
|
|
PTP-520380.16
|
Service Alert
|
The left pump max forward drive current is out of range high.
Calibration value is out of spec.
|
|
PTP-520380.31
|
Info
|
The left pump primary forward drive circuit has failed. Current
feedback is not within 5mA of commanded current.
|
|
PTP-520381.0
|
Service Alert
|
The left pump primary reverse drive circuit has failed. Current
feedback is above normal, Short to battery.
|
|
PTP-520381.1
|
Service Alert
|
The left pump primary reverse drive circuit has failed. Current
feedback is below normal, Short to ground.
|
|
PTP-520381.5
|
Service Alert
|
The left pump primary reverse drive circuit has failed. Current
feedback is out of range low.
|
|
PTP-520381.6
|
Service Alert
|
The left pump primary reverse drive circuit has failed. Current
feedback is out of range high.
|
|
PTP-520381.31
|
Info
|
The left pump primary reverse drive circuit has failed. Current
feedback is not within 5mA of commanded current.
|
|
PTP-522363.0
|
Service Alert
|
The right motor speed sensor power line is open
|
|
PTP-522363.1
|
Service Alert
|
The right motor speed sensor ground line is open
|
|
PTP-522363.3
|
Service Alert
|
The right motor speed sensor direction signal voltage is out
of range high, short to battery
|
|
PTP-522363.4
|
Service Alert
|
The right motor speed sensor direction signal voltage is out
of range low, short to ground
|
|
PTP-522363.5
|
Service Alert
|
The right motor speed sensor direction signal line is open
|
|
PTP-522363.7
|
Stop
|
Right motor speed detected at startup
|
|
PTP-522363.8
|
Service Alert
|
Right motor overspeed detected, runaway right pump
|
|
PTP-522363.10
|
Stop
|
Uncommanded right motor speed detected
|
|
PTP-522363.14
|
Service Alert
|
Right motor speed low for non zero right pump command
|
|
PTP-522363.16
|
Service Alert
|
The deadbands of the right pump drive determined during calibration
are out of range.
|
|
PTP-522363.31
|
Service Alert
|
The direction input line of the sensor which measures the rotational
speed of the right motor has failed.
|
|
PTP-522381.0
|
Service Alert
|
The left motor speed sensor power line is open
|
|
PTP-522381.1
|
Service Alert
|
The left motor speed sensor ground line is open
|
|
PTP-522381.3
|
Service Alert
|
The left motor speed sensor direction signal voltage is out
of range high
|
|
PTP-522381.4
|
Service Alert
|
The left motor speed sensor direction signal voltage is out
of range low
|
|
PTP-522381.5
|
Service Alert
|
The left motor speed sensor direction signal line is open
|
|
PTP-522381.7
|
Stop
|
Left motor speed detcted at startup
|
|
PTP-522381.8
|
Service Alert
|
Left motor overspeed detected, runaway left pump
|
|
PTP-522381.10
|
Stop
|
Uncommanded left motor speed detected
|
|
PTP-522381.14
|
Service Alert
|
Left motor speed low for non zero left pump command
|
|
PTP-522381.16
|
Service Alert
|
The deadbands of the left pump drive determined during calibration
are out of range.
|
|
PTP-522381.31
|
Service Alert
|
The direction input line of the sensor which measures the rotational
speed of the left motor has failed.
|
|
PTP-522855.13
|
Info
|
Left pump PWM dispalcements not calibrated.
|
|
PTP-522856.13
|
Info
|
Right pump PWM dispalcements not calibrated.
|
|
PTP-523216.0
|
Service Alert
|
Data Valid but Above Normal Operational Range - Most Severe
Level
|
|
PTP-523216.1
|
Service Alert
|
Data Valid but Below Normal Operational Range - Most Severe
Level
|
|
PTP-523217.0
|
Service Alert
|
Data Valid but Above Normal Operational Range - Most Severe
Level
|
|
PTP-523217.1
|
Service Alert
|
Data Valid but Below Normal Operational Range - Most Severe
Level
|
|
PTP-523218.1
|
Service Alert
|
Supply voltage VP2 for valve driver Out of Range Low.
|
|
PTP-523219.1
|
Service Alert
|
Supply voltage VP1 for valve driver Out of Range Low.
|
|
PTP-523326.13
|
Info
|
Invalid pump solenoid calibration data
|
|
PTP-523345.0
|
Service Alert
|
Secondary handle signal voltage above normal, short to high
|
|
PTP-523345.1
|
Service Alert
|
Secondary handle signal voltage below normal, short toground
|
|
PTP-523345.3
|
Service Alert
|
Secondary handle signal voltage out of range high, short to
attery
|
|
PTP-523345.4
|
Service Alert
|
Secondary handle signal voltage out of range low, short to ground
|
|
PTP-523345.14
|
Service Alert
|
The difference between primary handleposition and secondary
handle position is greater that 5 percent of primary position plus
150 mV and the secondary position is greater that half of the primary
position
|
|
PTP-523380.31
|
Info
|
Drive train derate conditionis Active
|
|
PTP-523498.14
|
Service Alert
|
Direction mismatch between left and right motors
|
|
PTP-523643.0
|
Service Alert
|
Primary hydro handle position signal voltage is above normal
|
|
PTP-523643.1
|
Service Alert
|
Primary hydro handle position signal voltage is below normal
|
|
PTP-523643.3
|
Service Alert
|
Primary hydro handle position signal voltage is out of range
high, shorted to battery
|
|
PTP-523643.4
|
Service Alert
|
Primary hydro handle position signal voltage is out of range
low, shorted to ground
|
|
PTP-523643.7
|
Stop
|
Hydro handle is not in nuetral position at startup
|
|
PTP-523643.13
|
Service Alert
|
The hydro handle has not been calibrated or invalid calibration
values in memory
|
|
PTP-523643.14
|
Service Alert
|
The difference between primary handleposition and secondary
handle position is greater that 5 percent of primary position plus
150 mV and the secondary position is greater that half of the primary
position
|
|
PTP-523651.2
|
Service Alert
|
Controller Malfunction: Stack Overflow.
|
|
PTP-523661.11
|
Stop
|
Steering motion was detected while the vehicle was in park.
|
|
PTP-523911.0
|
Service Alert
|
Varitorque pot position signal voltage is above normal
|
|
PTP-523911.1
|
Service Alert
|
Varitorque pot position signal voltage is below normal
|
|
PTP-523911.3
|
Service Alert
|
Varitorque pot position signal voltage is out of range high,
shorted to battery
|
|
PTP-523911.4
|
Service Alert
|
Varitorque pot position signal voltage is out of range low,
shorted to ground
|
|
PTP-523911.5
|
Service Alert
|
The varitorque valve drive circuit has failed. Current feedback
is out of range low.
|
|
PTP-523911.6
|
Service Alert
|
The varitorque valve drive circuit has failed. Current feedback
is out of range high.
|
|
PTP-523911.13
|
Service Alert
|
Varitorque pot not calibrated
|
|
PTP-523953.3
|
Service Alert
|
Primary and secondary hadle position signal voltages are out
of range high, short to battery
|
|
PTP-523953.4
|
Service Alert
|
Primary and secondary hadle position signal voltages are out
of range low, short to ground
|
|
PTP-523953.14
|
Service Alert
|
Primary and secondary hadle position signal voltages are out
of range but in opposite directions
|
|
PTP-524160.2
|
Info
|
Data Erratic, Intermittent or Incorrect
|
|
PTP-524249.14
|
Info
|
Operator out of seat while vehicle is moving for more than 10
seconds.
|
|
PTP-524254.3
|
Service Alert
|
Voltage Above Normal, or Shorted to High Source
|
|
PTP-524254.4
|
Service Alert
|
Voltage Below Normal, or Shorted to Low Source
|