Fill Cooling System

1. Close petcocks on engine.

2. To help avoid air pockets, add coolant slowly. Fill at 11 L (3 US gallons) per minute or less.

3. The factory recommended antifreeze is JD Cool Gard pre-diluted antifreeze. JD antifreeze/coolant can also be used in either a pre-diluted mixture or as a concentrate mixed with 40 to 60 percent of quality distilled water.

4. Add coolant to expansion tank as needed.

   NOTE: Air will bleed through the surge tank when cap is removed.

5. Inspect radiator cap, if gasket is damaged, replace cap. Start engine and observe coolant level. Add coolant, if necessary, when the level stabilizes.

6. Stop the engine and install radiator cap (A).

7. Every 25 hours reverse blow or wash the radiator to remove accumulated dirt and trash.

Item	Measurement	Specification
Cooling System	Capacity	69,6 L (18.4 U.S. gal)