Adjusting Twine Density

The twine density (spacing between coils) can be adjusted from 0.02 to 0.15 m (0.78 to 5.90 in.) when using two twines, and from 0.02 to 0.30 m (0.78 to 11.81 in.) when using only one twine.

Display and adjust twine density as follows:

Switch ON monitor in twine mode position.

Press and hold WRAP DENSITY key to display the current spacing. If this one is no longer required, keep on holding WRAP DENSITY key while pressing PLUS key to increase twine spacing, or while pressing MINUS key to decrease it.

Release the WRAP DENSITY key to store the last twine density entered.

NOTE: A short pressure on PLUS or MINUS keys gives an increment of 0.01 m (0.39 in.). A long pressure on those keys accelerates the increment display.

IMPORTANT: When using two twines, the distance selected on monitor must be the same as the space (A) between the two arms of the double twine arm (B). See "Adjusting Twine Spacing" in "Operating The Baler - General Purposes" Section.

AG,OUCC006,507 -19-31AUG00-1/1