Adjusting Twine Guide (Baler with Precutter Device)

Depending on the crop type, the twine guide (B) allows the operator to adjust the distance of the twine from the left end of the bale from 88 to 199 mm (3.46 to 7.83 in.).

IMPORTANT: Check that the twine guide position matches the BaleMaster Control Monitor setting. See "Adjusting Bale End Wrap Position" in "Operating BaleMaster Control" Section.

Adjust twine guide as follows:

Loosen lock nut (A).

Remove twine guide (B).

Install twine guide (B) in one of holes (1-2-3-4-5-6) and tighten lock nut (A).

NOTE: When using the baler for dry, slick crops such as straw or flax, use one of holes (4-5-6).

In this case, twine knife must be relocated in position (D) as shown.

When using the baler in normal operating conditions, use one of holes (1-2-3) and the position (C) for twine knife.

A-Lock nut
B-Twine guide
C-Twine knife position for holes 1, 2 or 3
D-Twine knife position for holes 4, 5 or 6
1-88 mm (3.46 in)
2-106 mm (4.17 in)
3-125 mm (4.92 in)
4-162 mm (6.37 in)
5-180 mm (7.08 in)
6-199 mm (7.83 in)

CC03745,00001C4 -19-08NOV00-1/1