Adjusting Pickup Height (Baler with Precutter Device)

Gauge wheels are designed to be constantly in contact with the ground. Adjust pickup height by positioning gauge wheel support (A) as follows:

Check first that precutter pickup operating mode is activated.

Act on selective control valve lever to fully raise the pickup.

Remove spring-locking pins (B) then choose one of the positioning holes (C) to fix support (A) on studs (D). Install spring-locking pins (B).

Repeat procedure on opposite side.

Act on selective control valve lever to fully lower the pickup.

A-Gauge wheel support
B-Spring-locking pins
C-Positioning holes
D-Studs

CC03745,00001CA -19-08NOV00-1/1