Adjusting Belt Tracking (Baler without Net Wrapping)

NOTE: Baler must be empty and gate closed.

With baler on a level surface, engage PTO and run at slow speed.

Observe belt tracking at lower belt guide.

If belts do not track correctly, use the following procedure:

On 590 Only: - Lock gate with gate lock valve.

Using tractor selective control valve, raise belt tension arm to slacken belts.

On All Models: - Shut off tractor engine.

If belts track to the right, lower right-hand end of lower gate roll (A).

If belts track to the left, raise right-hand end of lower gate roll (A).

Start engine, lower belt tension arm and recheck tracking. Readjust if necessary.

CC03745,00001D4 -19-08NOV00-1/1