Selecting Net Roll

In order to achieve optimum performance, we recommend the use of net roll which meets the following specifications:

• Material: High density polyethylene.
• Density: Minimum 10 g/m ² ±10% (0.033 oz/sq.ft.±10%).
• Strength (Wrap direction): 900 N/500 mm (662 lb/20 in.).
• Elongation: 15%±3%.
• Length: 3000±100 m (9842±305 ft.)
• Material width: 1222 +16 -11 mm (3 ft 11.7 in to 4 ft 0.7 in).
• Core width: Maximum 1255 mm (4 ft 1.4 in).
• Material/Core offset (A): 2 to 16 mm (0.08 to 0.63 in.) on both sides.

IMPORTANT: Net roll types with higher density can be used. In this case, make sure that net device is well adjusted and knife well sharpened. Refer to "Service" Section.

With a 3000 m (9842 ft.) long net roll, approx. 500 bales of 1.25 m (4 ft 1.2 in) diameter can be wrapped with 1 ¹ / ₂ turns of the net.

NOTE: Net roll diameter must not exceed 32 cm (12.6 in)

CC,570RB003440 -19-16SEP98-1/1